.

I had one jr bike recently (can&39;t remember which) that transformed from a sputtering no-idle disaster to a perfect bike by moving the e-clip on the main needle 1 notch.

.

- mixture screw changes making no. Dec 22, 2012 The Zinger runs but won&39;t come off idle.

If the bolts are 12mm.

Featuring a special lightweight flywheel to reduce rotating mass on the engine crankshaft.

5-17. If after an initial adjustment, the idle speed increases beyond the desired rpm, turn the idle speed screw counterclockwise to return the speed to the original engine speed. Dec 22, 2012 The Zinger runs but won&39;t come off idle.

the recommended torque is 25.

. . I had one jr bike recently (can&39;t remember which) that transformed from a sputtering no-idle disaster to a perfect bike by moving the e-clip on the main needle 1 notch.

2. This allows the engine to reach higher RPM more quickly.

492.

- mixture screw changes making no.

After I warm it up it will idle in the "start" position with no problem but as soon as I switch to "run" it seems like it's running at full throttle or. PW50 order direct from the largest PW Yamaha Spare Parts supplier.

. If more power is required, please consult a Yamaha dealer.

Start the engine and allow it to warm up for three minutes.
Aug 15, 2006 Turn up the idle a bit, sometimes they need to have the choke pulled (when hot) to start after they shut off.
.

The idle mixture screw meters the correct amount of fuel, not air.

I'd guess the Phillips air screw is 18-14" behind the gold plug.

Locate the smaller idle-adjustment screw and the larger fuel-air adjustment screw at the right side of the carburetor. How many turns out on the air screw for pw50 and how many for idle wingding New Member. .

The left carb, seemed to idle up a little bit around 34 to 1 turn. 5 main and 40 pilot (jets measured). start bike. The arrow should point towards the exhaust side of the engine. Throttle cables often have adjustment by means of threaded ends. then it confused me it says ADJUST IDLE MIXTURE SCREW COUNTERCLOCKWISE 18 TURN UNTIL ENGINE STARTS TO LOAD THEN BACK OFF 116 UNTIL ENGINE FIRES EVENLY AND RPMS INCREASE.

Locate the smaller idle-adjustment screw and the larger fuel-air adjustment screw at the right side of the carburetor.

It doesn&39;t slow down and it doesn&39;t stall and it kind of feels like its doing its best, but just can&39;t go any. It started first kick every time.

.

In other words, the bike wouldn't idle right until I took all the slack out of the throttle cable and THEN set the idleair screw combo properly.

But you should adjust the idle screw out to where the bike will barely idle when it&39;s set to Start, and then idle at a normal RPM when it is moved to Run.

then back out 1 78 - 2 38 turns.

Where is the idle screw on a pw50.